LG Washer, front-load and top-load code Cd
Cool down, drying cycle finished
Quick answer
On LG Washer, front-load and top-load (2000s onward), Cd is a normal display state, not a fault. Not a fault. The cooling step that lets the load cool before the door unlocks has finished, and the message stays up until the clothes are removed or the machine is started again. A first thing to check: Normal self-test after a software update.
- Applies to
- LG Washer, front-load and top-load
- LG front-load and top-load washer codes · Washing Machine · 2000s onward
- Type of code
- Status or setup value
- Urgency: nothing to fix
- First safe check
- Leave the machine powered and undisturbed until the code clears on its own.
What Cd means on this model
Not a fault. The cooling step that lets the load cool before the door unlocks has finished, and the message stays up until the clothes are removed or the machine is started again.
Symptoms you will notice
- Display shows the code while the drum turns slowly through a speed range
- Code appears straight after a power cycle or a child lock being released
- Cycle will not start while the code is showing
Common causes
The code tells you what the control detected, not which part failed. These are the causes we see most often, roughly in order of likelihood:
- Normal self-test after a software update
- Triggered by a power interruption that reset the stored reference values
- Sometimes deliberate, when the machine is being prepared for delivery or testing
What you can safely check
These are homeowner-level checks. None of them need you to open a live electrical compartment or work on gas.
- Leave the machine powered and undisturbed until the code clears on its own.
- Do not interrupt it, because interrupting a calibration is what sometimes causes the code to persist.
Do not do these
- ×Do not cut the power mid-calibration, and do not call a technician for it before it has had time to finish.
When to call a technician
Worth scheduling, and worth your own checks first
You can usually keep living with this for a short while, but it will not fix itself. Do the safe checks below first, because a tripped switch or a blocked airflow is a five-minute fix that would otherwise cost you a service call.
- If the appliance has stopped mid-cycle, is making a noise you have not heard before, or smells burnt, stop reading here and call. Those are symptoms of something the fault code does not describe well enough.
Nothing to do but wait. If it has not cleared in a reasonable period, power off and on once, then leave it again.
What it costs to fix
Parts
No parts.
Labor
No labour, provided the machine finishes the cycle on its own.
DIY or technician
Nothing to do but wait. If it has not cleared in a reasonable period, power off and on once, then leave it again.
Typical US part and labor ranges, 2026. They vary by region, model and contractor, so treat them as a planning figure, not a quote.
Scope of this code
- Code table
- LG front-load and top-load washer codes
- Models in scope
- LG Washer, front-load and top-load, 2010s onward
- Checked
- Confirm on your own unit
- Find the model number on the data plate, then check this code in the service manual for that model. Manufacturers revise code tables between model years, and a revised board can renumber a fault.